Scuba
Vacations Scuba
Diving Vacations Scuba vacation packages and trips for the ultimate getaway
Scuba Gear Brand Name Scuba
Equipment at Scuba.com A large selection of brand name Scuba Equipment at guaranteed
low prices.

Florida Scuba Diving Exclusive
scuba, snorkel and reef diving in Florida. We also offer scuba diving career instructor
and technician training which can lead to new lucrative job opportunities worldwide

Scuba Vacation Packages Scuba
Diving Vacations Scuba vacation packages and trips for the ultimate getaway. See
now
How
to Set up a Freshwater Aquarium
Decide where you want to put your
tank - this will determine what size you buy Choose a fish tank that fits the
space you have decided on. Get an aquarium stand that is designed for the dimensions
and shape of your tank. Make sure that the tank comes with a hood (lid), if
not, you'll need one of those too. Choose gravel or sand for the bottom -
this is essential to a healthy aquarium (approx. 2-3 inches). Decide which
filtration system you would like to use - the most common and easiest are either
undergravel filters or power filters that hang on the back of the tank. If
you decide to go with a power filter, select one that will circulate enough water
for the size of your tank. (Ideally, it should circulate 5 gallons of water per
hour [gph], per gallon of your tank capacity. Make sure you get a heater if
one doesn't already come with your tank - the fully-submersible ones are the easiest
to use. Put your tank where you want it to live - once it's filled with water
you won't be able to move it, so choose the spot wisely. Fish dont like high traffic
areas in general. Fill the tank with about two inches of water, then wait
for a half an hour. If there are any leaks, it's better they show up now, rather
than when you have filled the entire thing. For undergravel filters, put the
filter plate in, and make sure the lift tubes are fitted. Spread rinsed gravel
in an even layer across the surface of the filter. Fill the tank with water
to just under the rim of the tank - usually a gap of 1" will do. If you've
chosen an external power filter, set it up on the back of the tank in a position
where the outflow will evenly distribute the water. Some tank hoods come with
pre-perforated cut-outs which make it easier to position your equipment. Fill
the reservoir of the filter with water, and plug it in! Water should smoothly
(and quietly) circulate after a couple of minutes. Attach your pump airlines or
powerhead into the appropriate lift tube. Plug in the powerhead/pump. Water
should start moving vertically in the lift tube(s). Install your heater (suction
cups) on the inside of the tank. Plug in the heater and install your thermometer.
Add the water dechlorinator, according to the instructions on the bottle (if you
have not used purified drinking water) You should wait about 2 weeks at least,
and then check everything again. If it all is running smoothly, you're done. Now
you can go about putting in a few fish.
|
|